If the Contender is dropped or struck a hard blow, the following steps should be taken. Always keep the muzzle of your Contender pointed down range. Do not rely on the safeties to overcome the danger of injury to yourself or others from careless handling or abuse of your Contender.ĭO NOT LOAD THE CONTENDER UNTIL YOU ARE READY TO FIRE IT. They are intended to be used in combination with common sense and safe gun handling practices. The safeties on the Contender are mechanical devices and are not foolproof. NEVER CLOSE THE ACTION ON A LOADED ROUND UNTIL YOU HAVE CHECKED AND ASSURED YOURSELF THAT THIS SELECTOR IS SET IN ITS SAFETY (UNARMED) POSITION. At all times, except for the instant before and after firing this selector must be set in safety position 2. If you are using a Rim Fire cartridge, see insert on right.Īfter the shot is fired, open the action, remove the fired round AND IMMEDIATELY RESET THE EXTERNAL FIRING PIN SELECTOR TO SAFETY POSITION 2. NOTE: Illustration shows Center Fire selection. Support the pistol with two hands as you move the External Manual Firing Pin Selector into armed position.įor Rim Fire cartridges, et selector in this position. Never cock the hammer until the instant before firing. Aim carefully at the target and fire the shot! 8 Set the External Manual Firing Pin Selector to the fire position required for your cartridge (Rim or Center Fire). When you are ready to fire, support the pistol with two hands (as pictured in Photo E). The hammer is drawn to cocked position and the External Manual Firing Pin Selector set to an armed position (position 1 or 3) only during the act of firing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |